dmg provided by hackintosh zone since I don't have a Mac and I can't use UniBeast to create a bootable USB. I will upload pics of verbose mode in both PC's in a bit. I am not sure what other bootflags to use or what other methods to use. I boot into the drive and it stops progressing around the half-way mark. On the e9107c the USB boots quickly and the 1st part of installation finishes until it requires a reboot. It will run the installation using the bootflag 'npci=0x3000' but I have given up on it because after 90 minutes it still says 15 minutes remaining. On the a6157c desktop the USB takes forever to boot from (like at least 2 minutes) before I even get to the boot loader screen.insanely slow and I'm not sure why because it's. I downloaded their Yosemite Zone.dmg and restored the image using TransMac to create a bootable USB. Now, I am trying to install using Niresh's Yosemite from Hackintosh Zone. As such, the graphics was stuck at minimum resolution like 600 x 800 and the LAN didn't work.

I installed Iatkos V7 (Snow Leopard 10.6) a loooong time ago on the a6157c PC, but didn't pursue it much after initial installation.

Wireless Card: Qualcomm Atheros 802.11 a/b/g/n Dualband LAN: Realtek RTL 8168D/8111D Family PCI-E Motherboard: Pegatron IPIEL-LA3 (Eureka3) Processor: Intel Core 2 Duo E4400 Processor Thank you for posting your results, hnvijay.Motherboard: Asus P5LP-LE (Leonite2-GL8E) So, try at your own risk folks but it works for me, so far. The GN 621U seems to have the same id numbers as you list I writing this post through this connection.Hopefully this will help others using the cheap and popular GETNET GN 621U USB which came with only a Leopard driver on the CD and the same on their downloads page - it works fine in Snow Leopard in 32bit but not at all in 64bit. Vendor ID:Đx0bda (Realtek Semiconductor Corp.)

This driver works fine on RTL8191SU USBN Realtek wifi USB dongle on SL 10.6.4 x86_64.

Iatkos v7 realtek wifi drivers